Installation Guide

.
.
“Backset”
Screw must be at least
1” from edge
Inside
Outside
Use a tape measure to position
the panel on the “backset”
dimension and parallel to the
outside of the curb.
If the space is less than 1 inch move the glass
closer to the outside of the curb.
With a helper, place the glass panel in position on
the center of the curb. Check the spacing of the
screw hole in the clip and the edge of the curb.
2
Position the Panel
3
Use a level to plumb the panel and mark
the three hole positions with a Sharpie™.
Reposition the panel on the
protective cardboard and drill the
three holes in the market positions.
4
Level & Mark
Drill
If the drilled holes go directly into a stud,
switch to a 3/16” bit to drill the stud. To
prevent water infiltration, fill the hole
with silicone before installing screws.
1/4”
Bit
3/16” Bit
If the drilled holes go into drywall or backer board, drill a
¼” hole, fill the hole with Silicone Sealant and tap the
provided wall plug into place with a hammer or mallet.
Use a Razor Knife to trim the head of the Wall Plug flush
with the surface. This will allow the hardware to lie flat
on the wall.
¼”Bit
Tap Into
Place
Trim Flush With
Surface
Wood Stud
Drywall or Backer Board