Installation Guide

Reposition the fixed panel and attach
with the three screws provided.
For proper alignment with the
door, it is critical that this
edge of the fixed panel is
plumb.
Add shims here to plumb
the panel as shown.
Add shims here to shift
the panel as shown.
Loosen the face
plates of the
hinges with the
Allen wrench
provided.
Clean the edges
of the glass with
an alcohol pad
and position the
hinge into the
glass notch as
shown.
Tighten the Allen screws and repeat for
the remaining hinge.
If this wall is
not plumb
there may be
an uneven
gap between
the glass and
the wall. This
will be
corrected in
Step 13.
Cut-Out in Glass
Hinge
Press the Hinge
Tight to the
backside of the
cutout and
centered
vertically in the
cutout.
5
If necessary, loosen the set screws and plumb the
panel by adding additional shims to one of the
bottom clips. Securely re-tighten the three set
screws with a flat screwdriver.
6
Leave the door panel on the protective cardboard as you
install the two hinges.