Installation Guide

Remove the three clips, clear shims and alcohol wipes from the
hardware box. Note there are two thicknesses of shims.
Clean the corners of the glass with an alcohol pad and attach the
clips to the fixed panel as shown. Place one of the thinner shims
between the bottom of the glass and the bottom clips. Tighten
the set screws with a flat-blade screwdriver.
.
.
“Backset”
Screw must be at least
1” from edge
Inside View of In-Line Panel
Press Clear Shims Under
Glass & Inside Bottom
of the Clips
1”
Tempering
Stamp
Inside
Outside
Use a tape measure to position
the panel on the “backset”
dimension and parallel to the
outside of the curb.
If the space is less than 1 inch move the glass
closer to the outside of the curb.
With a helper, place the fixed panel in position on
the center of the curb. Check the spacing of the
screw hole in the clip and the edge of the curb.
2
Carefully unpack the door and panel and using the
box as a protective pad, stand them against the wall
as shown. Note the tempering stamp and position
the door and panel with the stamp to the bottom.