Installation Guide

7
8
Install the exterior
handle with the
washers and spacers in
the order shown.
Press the interior handle
over the attachment studs
and tighten the Allen
screws with the wrench
provided. Note the Allen
screws face down.
Tighten the
attachment studs
with a Phillips
screwdriver.
You will begin the door
installation with a 1/2”
space at the bottom. This
dimension will be adjusted
in the following
With your helper,
carefully place the door
into position on the
spacers. Press the clear
drip rail over the top of
the door and panel to
hold the door in position.
1/2”
Press the hinges tight to the
wall and use a tape measure
to duplicate the “backset”
determined in Step 2. This will
ensure the door is parallel to
the curb and in line with the
fixed panel.
Place the spacers on the curb as shown.
steps to align the door with the fixed
panel. Create a temporary spacer by
stacking wood shims until they are
approximately 1/2” thick and
temporarily securing with masking
tape.