Owner's manual

Symphony Cooler
Installation
Before Startup
• Check that another door or window in the room is open to allow air to exhaust to other parts of the
house.
• Ensure that the filters are kept clean.
• Ensure that the water tank is filled with clean water (at least 5 gallons or 20 liters).
• Plug the cooler into a 110 V - 120 V~ 60 Hz single phase grounded appliance socket on the inside
of the house and switch the socket on.
• Press the COOL button to on the water pump.
• Press the Speeds buttons and check the operation of the three speeds motor.
• Leaving the unit in the COOL mode for 15 minutes, you may notice a wet paper smell as the water
circulates around the filter pads. This is normal during the commissioning phase and at the beginning of
each season when the unit is operated after the winter break. It will only last for a short time.
• Drain completely water tank removing drain plug and refill again the water tank to water level
desired.
• Do not add any chemical odor enhancers or liquid detergent of any kind to the tank.
• IMPORTANT. After the first 10 hours of operation in COOL mode, the water must be drained from
the unit water tank to remove any new product residuals. This process must be repeated after a
further 10 hours of COOL mode operation. (See page 12 for removing the Drain Plug). To clean
the tank you must only remove the Drain Plug.
Page
10