Owner's manual
Symphony Cooler
Introduction
GENERAL INFORMATION
Thank you for purchasing a quality Symphony Evaporative Cooler. We care about your safety and would
ask you to spend a few minutes reading these simple instructions before installing or operating this
product.
Safety!
Read carefully all of these instructions prior to installing
and operating the unit.
• Read and Save these Instructions.
Do not throw these Instructions away.
• Complete the unit assembly before attempting to install, refer to pages 7-8.
• Installation of this cooler in any manner not prescribed by these instructions could cause a safety
issue and WILL avoid any warranty.
• Use only with a 110 - 120 V~ 60 Hz single phase grounded outlet.
• Do not operate cooler with Rear and Side Filter Panels removed.
• Do not operate cooler with a damaged cord, plug or other component.
• Do not run the power cord under carpet or other floor covering.
• Do not use the power cord with an adaptor plug that converts the 3 pin plug into a 2 prong connector.
• Do not use the cooler with an improperly grounded outlet.
• Do not alter or modify this cooler.
• Do not allow children to install, operate or service this cooler.
• WARNING: To reduce the risk of fire or electric shock, do not use this product with any solid state
speed control device.
• Use only qualified electricians for replacement or servicing of switches, or electrical motors and
components in this cooler.
• Unplug the cooler and press the Motor switch to the OFF position when installing, servicing or cleaning.
• Stagnant water may cause bacterial growth and serious health problems. Do not allow
stagnant water to remain in the tank.
• Drain and clean the water tank before storage, after seasonal use and whenever the unit is not in daily
use.
This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock,
this plug is intended to fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.
Page
2