OPERATION MANUAL BLACK MIDBACK LEATHER CHAIR
CONTENTS EXTRA SPARE HARDWARE INCLUDED FOR YOUR CONVENIENCE. ITEMS ARE NOT SHOWN TO SCALE. PARTS LIST PART DESCRIPTION HARDWARE KIT STOCK# 61-SCRWSETB STOCK# QTY..
ASSEMBLY INSTRUCTION DO NOT TIGHTEN SCREWS UNTIL COMPLETELY ASSEMBLED STEP 1 STEP 2 Insert casters (G) into holes of star base (F). Insert gas lift (E) into center hole of star base (F). Place gas lift cover (H) over gas lift (E) as shown. Align seat plate (D) over pre-drilled holes under seat cushion (B). (NOTE the position of seat plate handle to seat cushion FRONT). Attach seat plate (D) to seat cushion (B) using four screws (K) and four washers (J) as shown. Tighten securely with allen wrench (M).
FUNCTION INSTRUCTION TO ADJUST SEAT HEIGHT 360 DEGREE SWIVEL While seated, lean forward, lifting your body weight from the seat. Reach underneath the right side of chair and locate the handle. Lift the handle up slowly to allow the chair to rise to the desired height. To lower seat height, lift the handle slowly while seated.
FREQUENTLY ASKED QUESTIONS • WHERE DO I FIND THE MODEL NUMBER AND SUPPLIER CODE FOR MY CHAIR? The chair model number and supplier code is located on a sticker underneath the seat cushion, and on the front page of your instruction manual. • HOW DO I ORDER REPLACEMENT PARTS? WHEN AM I GOING TO RECEIVE THEM? Simply fill in the information, and the part you need. If your chair is covered under warranty, there is no charge for replacement parts. We normally ship replacement parts within 48 hours.
SAFETY AND MAINTENANCE • • • • • • • DO NOT stand on the chair. DO NOT use the chair as a stepladder. Use this product for seating one person at a time. DO NOT use this chair unless all bolts and screws are firmly secured. Avoid contact with sharp objects to prevent puncturing the fabric. Every 6 months, check all bolts and screws to ensure they are tight. To clean, spot clean only using a damp towel and mild cleaner. First test on a small, obscure area of fabric. Chair weight limit not to exceed 225 lbs.
REMOVING A 5-STAR BASE FROM YOUR OFFICE CHAIR (NOTE: YOUR PARTS MAY DIFFER SLIGHTLY FROM THOSE SHOWN BELOW) TOOLS NEEDED: (1) Newspaper or cardboard for work area, (2) Silicone lubricant (such as WD40),(3) Rubber Mallet FIGURE A INSTRUCTIONS: 1.) Spread newspaper or cardboard on your work surface. 2.) Turn your chair on its side. 3.) Spray lubricant around the center post where connected to your 5-star base. 4.) Remove casters (wheels) from base. 5.
