Installation Instruction UNPACK -RUCTIONS _ is and lay out on cardboard or other Carefully open the carton, Remus protective surface lo avoid damage. Check package contents against the Supplied Parts {ist in the next page lo assure that all components were received undamaged. Do not use damaged or defective parts. Careful y read all instructions Lenore attempting installation. IMPORTANT SAFETY IN FORMATION th care Please read this instruction before {stall and operate this device wi rained herein.
Ee Connecting L Plate to Keyboard Tray Warning: ZN Ensure screws are secured firmly.
1 Installing a 10 the sores 2 nga in liveliness gy desktop Ensure screws are | Warning: 4 secured firmly. Warning: Don't operate the | workstation is flh ever until the WO partition, Tithe Keyboard fray Vv assembled.
— hing Lever to the Attaching the Back of Monitor Platform + Warning: Note: The lever can be installed Erie st are nigher on the right or the left secured Army.
Installation Instruction UNPACKING INSTRUCTIONS ® Carefully open the carton, remove cote ton cardboard or other protective surface to avoid damage. & Check package contents against the Sup. «5 Liston the next page fo assure that all components were received undamaged. Lo nol use damaged or defective parts, ® Carefully read all instructions before attempting Installation. IMPORTANT SAFETY INFORMATION @ install and operate this device with care.
In stat me role to the Desktop mesa golf Drilled Grommet Hole Installation 1 Position the Fol eta) on the mounting sacrifice and mark the center hole. Drill a 3/8" (comm) diameter hole at the marked position through the mounting surface. 5 install the Grommet Base Plate(m) to the Pole fa) using PCs MBx14 Abolish, and tighten using the Allen Keven, see Figure 7. 3. Attach Soft Padded) to the Grommet Base Plainsmen, see Figure 8 4.
o the Monitor Attach the VASE Plate t For Monitor with Curved or Recessed Back Slide the monitor onto the head of Install the security Nutty. Make sure the Swivel Arm(d) as shown in the above ! security nut is installed before you rotate diagram. the monitor.
oa Ex the he tilt angle Necessary Adjustments the bolt with the lathed Al en Tight Key lo) to fix the Hit angle. Nonage dt the Wires and Fore © meg ' Supplied All mak Ignore this step monitors are level | If une monitor is lower, remove the Nutty) . and turn the bolt counter-clockwise with supplied Allen key(o) to raise the monitor. | Install the Nut(h) after the adjustment.
