Owner Manual

3
OPERATION
1. Light Fixture - Be sure the fixture switch is in the “on” position, indicated by straight line, and
charge for at least 8 hours in full sunlight exposure. Note: battery will charge in both the ON and
OFF position.
2. PIR Sensor - Sensitivity, lighting time and ambient luminance can be readjusted by selector
buttons located at the PIR controller.
ADJUSTABLE RANGE as below:
Detection Motion Range Sensitivity: maximum 40 feet
Lighting time: Adjustable between 30 seconds to 10 minutes
Ambient luminance adjustable between: 5~60 lux
Lighting time and ambient illuminance when activated can be readjusted by button located at the top of PIR (Fig.2)
a. Press button SELECT to select TIME or LUX to be readjusted.
b. Press button of arrow to select lighting time or ambient lux when activated according to correspondent NO as
below.
NO
0
1
2
3
4
5
6
7
8
9
Lighting time (min)
0.05
0.5
1
1.5
2
3
4
6
8
10
Ambient luminance (lux)
5
15
35
60
60
60
60
60
60
At night it can be activated by motion and turns off at dawn (light will only come on at night).
BATTERY CHANGING- LED UNIT
SELECT
ADJUST
lux
Time
8
NO
Fig.2
3. Remote Control Operation
The unit can be operated conveniently with the supplied 2 button remote control. The red light on
remote control illuminates to confirm button depression for both ON and OFF selections. Remote
has range of approximately 75 feet when the antenna is extended. For shorter distances, do not
extend the antenna. The Remote Control includes a convenient wall mount hook slot on the back
of the transmitter.
The Lithium iron phosphate battery included with this light is rechargeable. Like all rechargeable
batteries, it will eventually need to be replaced. If the light should begin to illuminate dimly or for
shorter durations of time, you should replace the rechargeable battery in the following way (Fig3):