Installation & Assembly

ASSEMBLY INSTRUCTIONS

Slide SHELF (B) carefully top side down over

each LEG (C) at same time, until it rests on the

bottom of TABLE TOP (A).

Place TABLE TOP (A) top side down on a clean

smooth surface. Screw each LEG (C) into

circular collars on corners of TABLE TOP

(A). Tighten clockwise until fully secured.

STEP 1

STEP 2

A (1) C (4)

B (1)

PAGE 1
ASSEMBLY INSTRUCTIONS STEP 1 Place TABLE TOP (A) top side down on a clean smooth surface. Screw each LEG (C) into circular collars on corners of TABLE TOP (A). Tighten clockwise until fully secured. A (1) C (4) C A STEP 2 Slide SHELF (B) carefully top side down over each LEG (C) at same time, until it rests on the bottom of TABLE TOP (A).
PAGE 2
ASSEMBLY INSTRUCTIONS STEP 3 D Note that each LEG (C) has slight horizontal line indentations. Each SLIP SLEEVE (D) has raised horizontal lines inside designed to lock them in place on LEG (C). On LEG (C), place 1 pair of SLIP SLEEVES (D) at the desired level. Make sure arrow points down and word “TOP” is upside-down. Slide pair of SLIP SLEEVES (D) up until you hear a click to confirm pair is locked onto LEG (C). Do this at the same height for each LEG (C).