Installation & Safety Instructions

WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE
WORKING ON IS SHUT OFF; EITHER THE FUSE REMOVED OR THE
C IRCUIT BREAKER OFF.
RISK OF FIRE: Exceeding maximum wattage may result in over-heating
conductors. Read instructions carefully. If you are unclear as to how to
proceed, consult a electrician.
(USE ONLY WITH AMBIANCE 105˚ CABLE)
1. Secure surface mount ring to surface
by marking hole location on surface
and screw surface mount ring to
surface making sure surface mount ring does not
ex out of round.
2. Drill wire exit hole in surface or run wire thru notch in surface moun
t ring.
3. Line up retaining springs on
ture housing with grooves in surface
mount ring and press xture housing into surface mount ring.
1. Drill a 2 3/4” dia. hole in shelf surface.
2. Press
ture housing into
2 3/4” dia. hole.
SURFACE MOUNTING
FOR YOUR SAFETY
RECESS MOUNTING
*
NOT INCLUDED
*
NOT INCLUDED
*
TRIM
1/8”
HOOKS (2)
SLOTS (4)
RETAINING SPRING (2)
SURFACE
MOUNT
RING
SCREWS (2)
GROOVES (2)
HOLES (2)
NOTCH
FIXTURE
HOUSING
*
Lamp
2 3/4”
NOTCH
CONTACT
*FUSED
PLUG
*CABLE
*TRACK
FIXTURE WIRE
U.S. PATENT #5,465,199
FIG. 1
*FUSED
PLUG
*NOT INCLUDED
FIXTURE
WIRE
PLUG
ATTENTION: RISQUE D'INCENDIE. UTILISER SEULEMENT 12V LAMPES AVEC
LES SYSTÈMES 12V. UTILISATION DE LAMPES 12V 24V SYSTEME PEUT
PROVOQUER DES DOMMAGES AU SYSTÈME ET ALENTOURS
(UTILISER UNIQUEMENT AVEC LE CÂBLE 105˚ DE L'AMBIANCE)
CAUTION-RISK OF FIRE MAX 18 WATT TYPE WEDGE T5
ATTENTION-RISQUE D'INCENDIE MAX 18 WATT TYPE WEDGE T5
INSTALLATION AND SAFETY INSTRUCTIONS
CAUTION: RISK OF FIRE. Use only 12V lamps with 12V systems.
Use of 12V lamps with 24V system may result in damage to the
system and surrounding area.
CAUTION: RISK OF FIRE. Must use fused plug ifused with
transformers over 60w at 12 volts or 100w at 24 volts.
ATTENTION : RISQUE D'INCENDIE. Devez utiliser fiche fusionnés
si utiliser avec transformateurs sur 60w à 12 volts.