Installation And Safety Instructions

W
ARNING:
B
E SURE THE ELECTRICITY TO THE WIRES YOU ARE
WORKING ON IS SHUT OFF; EITHER THE FUSE REMOVED OR THE
C
IRCUIT BREAKER OFF.
RISK OF FIRE: Exceeding maximum wattage may result in over-heating
c
onductors. Read instructions carefully. If you are unclear as to how to
proceed, consult a qualified electrician.
(USE ONLY WITH AMBIANCE 105˚ CABLE)
1. Secure surface mount ring to surface
by marking hole location on surface
and screw surface mount ring to
surface making sure surface mount ring does not flex out of round.
2. Drill wire exit hole in surface or run wire thru notch in surface mount ring.
3. Line up retaining springs on fixture housing with grooves in surface
mount ring and press fixture housing into surface mount ring.
1. Drill a 2 3/4” dia. hole in shelf surface.
2. Press fixture housing into
2 3/4” dia. hole.
SURFACE MOUNTING
FOR YOUR SAFETY
RECESS MOUNTING
*
NOT INCLUDED
*
NOT INCLUDED
*
TRIM
1/8”
HOOKS (2)
SLOTS (4)
RETAINING SPRING (2)
SURFACE
MOUNT
RING
SCREWS (2)
GROOVES (2)
HOLES (2)
NOTCH
FIXTURE
HOUSING
*
Lamp
2 3/4”
NOTCH
CONTACT
*CABLE
*TRACK
FIXTURE WIRE
FIG. 1
*NOT
INCLUDED
FIXTURE
WIRE
PLUG
INSTALLATION AND SAFETY INSTRUCTIONS
U.S. PATENT #5,465,199
CAUTION: RISK OF FIRE. Use only 12V lamps with 12V systems.
Use of 12V lamps with 24V system may result in damage to the
system and surrounding area.
CAUTION: RISK OF FIRE. Must use fused plug ifused with
transformers over 60w at 12 volts or 100w at 24 volts.
*FUSED
PLUG
*FUSED
PLUG