Owner Manual
PREPARATION
ELECTRIC INSERT: PARTS & HARDWARE
DescriptionItem
A
B
1
1
Qty
Fireplace Insert
Remote Control
2
ALWAYS turn this heater off before unplugging it from the outlet.
ALWAYS disconnect this unit from the power supply and allow time for it to cool before performing any assembly or
cleaning and before relocating the electric fireplace.
NEVER leave this heater unattended while on. ALWAYS unplug this heater when not in use.
ALWAYS store this heater in a dry location. NEVER use the fireplace if it has become wet. DO NOT touch with wet hands.
NEVER plug this heater into an outlet that is old, cracked, or has any loose wires or connections. Plugging this heater
into a faulty outlet could result in electric arcing within the outlet that could cause the outlet to overheat or catch fire.
ALWAYS check your heater cord and plug connections with each use!
i) MAKE SURE the plug fits tightly in the outlet! Faulty wall outlet connections or loose plugs can cause the outlet to
overheat.
ii)
Heaters draw more current than small appliances. Overheating may occur even if it has not occurred with the use
of other appliances.
iii) During use
check frequently to see if the plug outlet or face plate is HOT!
iv) If the outlet or face plate is HOT, discontinue use immediately and have a qualified electrician inspect and/or
replace the faulty outlets.
This product includes a GLASS panel!
Always use extreme caution when handing glass. Failure to do so
could result in personal injury or property damage.
Remove all parts and hardware from the carton and place them on a clean, soft, dry surface. Parts and assembly
steps are grounded for wall-hanging or recessed use. Check the parts list to make sure nothing is missing. Dispose
of packaging materials properly. Please recycle whenever possible. You will need the following tools (not included):
Phillips screwdriver; stud finder; level; tape measure; electric drill; 1/4" wood drill bit, hammer.
The remote control uses one 3V CR2025 lithium cell battery (included).
NOTE:
Tools required for installation: Phillips screwdriver (Not included)