Owner Manual

PREPARATION
3
Read and understand this entire owner’s manual, including all safety information, before
using this product. Failure to do so could cause electric shock, fire, or serious injury.
NEVER leave the heater unattended during operation! Failure to do so could result in
personal injury or property damage.
ALWAYS replace the battery in the remote control with the same type of battery. Failure to do so may
result in personal injury or property damage.
When you first receive the remote control, pull out the plastic sheet between the battery and its electrical contact. To replace
the battery, press the button as shown below to let the case slide out. Position the new battery where the old one was and
slide the case back into the remote.
Remote Control Set-up
Make sure the power switch, located on the control panel, is in the OFF position. Plug the power cord into a 15A 120V
grounded AC outlet. Make sure the outlet is in good condition and that the plug is not loose. NEVER exceed the maximum
amperage for the circuit. DO NOT plug other appliances into the same circuit.
Power
Fig.1 Fig.2