Owner Manual

CARE AND MAINTENANCE

ALWAYS turn the heater OFF and unplug the power cord from the outlet before cleaning, performing

maintenance, or moving this fireplace. Failure to do so could result in electric shock, fire, or personal injury.

NEVER immerse in water or spray with water. Doing so could result in electric shock, fire, or

personal injury.

This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe temperature, the heater will

automatically turn OFF. To reset:

1. Unplug the power cord from the outlet.

2. Turn the power switch on the control panel to OFF. Wait 15 minutes.

3. Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint. If they are, use a vacuum to clean

the vent areas.

4. With the power switch in the OFF position, plug the power cord back into the outlet.

5. If it switches off again, UNPLUG THE HEATER RIGHT AWAY! Have the outlets, wiring, and breaker box inspected by a

professional. Make necessary repairs before using the heater

When the heater is first turned on, a slight odor may be present. This is normal and should not

occur again unless the heater is not used for a long period of time.

Temperature Limiting Control

Cleaning

Press once to activate the fan and start the

low level heater. Press again to start the full

heater. Press again to turn off the heater.

The fan will blow cool air and then turn off

automatically.

Adjusts the thermostat between 62 and 82°F

The heater will only activate when its sensor

detect that the ambient room temperature is

below the set temperature.

Press to set a time limit from 1–8 hours, after

which the fireplace will shut off automatically.

NOTE

HEATER

TEMP

TIMER