User Manual

Table Of Contents

HCTAG Data Sheet ∙ Document Number 430157-01A ∙ Page 7 of 7

modifications to this device not expressly approved by Synapse Wireless Inc. could void

the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses, and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation.

If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

RF Exposure Warning:

“This equipment complies with FCC radiation exposure limits set forth for an

uncontrolled environment. This equipment is in direct contact with the body of the user

under normal operating conditions. This transmitter must not be co-located or operating

in conjunction with any other antenna or transmitter.”