User Manual
Table Of Contents
Agency Certifications
United States (FCC)
The Model RF220 modules comply with Part 15 of the FCC rules and regulations. Compliance with the labeling
requirements, FCC notices, and antenna usage guidelines is required. In order to comply with FCC Certification
requirements, the Original Equipment Manufacturer (OEM) must fulfill the following requirements.
1. The system integrator must place an exterior label on the outside of the final product housing the RF220
Modules. FCCLabel on page 10. shows the contents that must be included on this label.
2. RF220 Modules may only be used with the antenna that has been tested and approved for use with the
module. Please refer to the antenna table provided in this section.
OEM Labeling Requirements
NOTICE: The OEM must make sure that FCC labeling requirements are met. This includes a clearly visible exterior
label on the outside of the final product housing that displays the contents shown in FCCLabel on page 10. .
MANUFACTURERSNAME
BRANDNAMEor TRADENAME
Contains FCC ID: U9O-RF220SU
This device complies with Part 15 of the FCCRules. Operation is subject to the following two conditions:(1) This
device may not cause harmful interferences, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Figure 5: FCCLabel
FCC Notices
WARNING: The RF220 modules have been tested by the FCC for use with other products without further
certification (as per FCC Section 2.1091). Changes or modifications to this device not expressly approved by
Synapse Wireless Inc. could void the user’s authority to operate the equipment.
NOTICE: OEM’s must certify final end product to comply with unintentional radiators (FCC Sections 15.107 and
15.109) before declaring compliance of their final product to Part 15 of the FCC Rules.