User Manual

Table Of Contents

Model SM200 Data Sheet · Document Number 430145-01B · Page 15 of 21

1.6.7 Hand Soldering

Hand soldering is possible. Use a soldering iron temperature setting equivalent to

350°C, follow IPC recommendations/ reference docume nt IPC-7711.

1.6.8 Rework

The Model SM700 Module can be unsoldered from the host board. Use of a hot air

rework tool and hot plate for pre-heating from underneath is recommended. Avoid

overheating.

Warning: Never attempt a rework on the module itself (e.g. replacing individual

components). Such actions will terminate warranty coverage.

1.6.9 Additional Grounding

Attempts to improve module or system grounding by soldering braids, wires, or cables

onto the module RF shield cover is done at the customers own risk. The numerous

ground pins at the module perimeter should be sufficient for optimum immunity to

external RF interference.

2.0 Agency Certifications

2.1 United States (FCC)

The Model SM200 module complies with Part 15 of the FCC rules and regulations.

Compliance with the labeling requirements, FCC notices and antenna usage guidelines

is required. In order to comply with FCC Certification requirements, the Original

Equipment Manufacturer (OEM) must fulfill the following requirements.

1. The system integrator must place an exterior label on the outside of the final

product housing the SM200 Modules. Figure 2.1 shows the contents that must

be included in this label.

2. SM200 Modules may only be used with the antenna that has been tested and

approved for use with the module. Please refer to the antenna table provided in

this section.