User Manual
Table Of Contents
DRAFT COPY
Generated on
9/16/2014
SNAP Engine SM220 Modules Overview
The SNAP Engine Model SM220 series currently consists of the SM220UF1. It is an IEEE 802.15.4,
low-power, highly reliable solution for embedded wireless control and monitoring networks that
require high data rates. The Model SM220 embeds Synapse’s SNAP OS, the industry’s first
Internet-enabled, wireless mesh network operating system, into the Atmel ATmega128RFA1
single-chip AVR
®
microcontroller with an integrated transceiver that delivers up to 2Mbits/sec. This
low-cost module can have current consumption under 390nA to enable a new generation of battery-
driven systems. The SM220 also includes a Skyworks SE2431L front-end module, which provides a
power amplifier and LNAfor increased range.
SNAP’s on-board Python interpreter provides for rapid application development and over-the-air
programming, while Atmel’s low-power RF single-chip design saves board space and lowers power
consumption. The modules provide up to 15 channels of operation in the ISM 2.4GHz frequency
band.
This data sheet covers part number SM220UF1:
• 36 GPIO with up to 7 A/D inputs
• 128k flash, 58.5k free for over-the-air uploaded user apps
• Two UART ports for control or transparent data
• Low power modes:
• Timed Sleep Mode 1: 1.27 µA
• Timed Sleep Mode 2 : 1.47 µA
• Untimed Sleep Mode : < 390 nA
• Spread Spectrum (DSSS) technology
• Up to 2 Mbps radio data rate
• 2.4 GHz RF Frequency
• AES 128-bit encryption
• Integrated compact F antenna or U.FL connecter
• Surface Mount, Solder-able
• 4K internal EEPROM
• 8 PWM outputs
1
SNAP Engine SM220 Series Data Sheet — 430000-01A