Wireless Sensor Network Node Installation and User Manual Document Number Author Revision Date 85-0xxx-001 Pat Weston Prerelease 4 19 October 2010 2365 Iron Point Rd Suite 100 Folsom CA 95630
This manual covers the general installation of the following SynapSense Wireless Sensor Network Nodes: • • • • • • • • • • 99-0039-002 99-0039-011 99-0039-012 99-0039-015 99-0189-001 99-0217-001 99-0331-001 99-0348-001 99-0360-001 99-0766-001
Regulatory Information Notice to Users: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
Warranty Information Limited One Year Warranty Our company warrants that for two years from the date of purchase, it will replace this product if found to be defective in materials or workmanship. For a prompt, no charge replacement of equivalent product, return the defective product postage prepaid to the appropriate address. Product Support Center 2365 Iron Point Road, Suite 100 Folsom, CA 95630 United States of America This replacement is the company's sole obligation under this warranty.
1. Operation The SynapNet Node is designed to work in conjunction with a SynapNet Gateway device and the SynapSoft console. Please be sure you have correctly configured SynapSoft on the gateway computer prior to continuing. SynapNet nodes can be added to an existing SynapSense Wireless Network (driven by a SynapNet Gateway) or be used to form a network.
f. Turn On/Off switch to ON position (For Remote Gateway 2 this is marked as a I on the faceplate). g. The device will attempt to join any available SynapSense Wireless Sensor Networks. For more information on network formation, node placement, please see the SynapSense Wireless Network User Guide. Troubleshooting and Diagnostics: 1.
external sensor ports. The diagnostic lights will light and flash when the node has successfully reset. 5. The Red LED is flashing on Remote Gateway 2: This indicates the node is operating in battery backup mode. This is caused by loss of 5VDC power supplied to the DC Jack connector. Check the external wall adapter is plugged in and has power. 6.
