User's Manual

SynapSense Intelligent Gateway Installation Guide
December 17, 2013
17
Installing the Gateway
Assess the installation location and determine which type of mounting is best.
• If the location requires an adhesive mount, proceed to 3M Command Strip
instructions.
• If the location requires a mounting shelf, proceed to Gateway Mounting Shelf instructions.
3M Command Strip
1. Clean installation surface with alcohol wipes. Allow area to dry thoroughly.
2. Attach two Command Strips (double-sided adhesive strips) to the back of the Gateway.
3. Connect the Power Adapter to the Gateway and the designated power outlet.
4. Connect the designated Ethernet Cable (originating from a server port assigned by the data
center's IT department) to the Gateway.
5. The Radio Activity LED will remain ON to indicate on-going radio communication activity.
6. The Unit Status LED will remain OFF unless there is a problem. See Troubleshooting
for a table
of status colors.
7. Remove adhesive covers from the Command Strips on the back of the Gateway.
8. Mount the Gateway onto cleaned surface (i.e. top of server cabinet). Press firmly for 30 seconds.
9. Secure and route Power Adapter wire and Ethernet Cable using adhesive Cable Clips.