User's Manual

CHAPTER 4.
Installation Inspection
Inspections ensure installations are correct and Gateway devices communicate with SynapSense Web
Console™.
Inspect Operations and Appearance
1. Verify all installed Gateway devices are connected properly (Power Adapter, Ethernet Cable, etc.)
and receiving power.
2. Verify Gateway devices are installed in areas in which there is a clear line of sight for wireless
sensor’s radio transmissions.
3. Verify Ethernet cables and Power Adapter wires are secured where needed.
Inspect Software Communication
Perform the following steps to confirm Gateway operations and communications (Figure 26
corresponds with steps 1 through 4). Refer to the Web Console User Guide for detailed information.
1. Access the SynapSoft Web Console software and select the appropriate data center from the Sites
list.
2. Click the Floor plan tab in the Data Center section.
3. Select the slide-out menu on the right of the screen then select Wireless Sensor Network.
4. Select the appropriate settings for the network as needed (Network: and Hop Level: dropdown
lists, and associated checkboxes).