User's Manual

Subfloor EZ Node Hardware Installation Guide
Version 1.0
3
Item
Description
Denotes a safety warning of a physical or electrical nature
Document References
The documents listed in this section affect the activities in this document. Refer to the appropriate
document for user-specific information.
 Web Console™ User Guide
 MapSense™ User Guide
 Active Control™ User Guide
 SynapSense Software Installation Guide
Warnings and Precautions
The following warnings and precautions pertain to Subfloor EZ Node installations. Failure to adhere
to warnings and precautions could result in physical injury or damage to equipment, which may void
the warranty.
Warning: Data centers may pose a risk of hearing loss. Use appropriate ear protection
prior to entry into high-noise areas.
Warning: When performing subfloor work in a data center, be careful not to stress,
crush, pull, or disconnect wiring and hoses running underneath electrical and data
cables, leak detectors, etc. (including fire alarm/suppression systems).
Warning: Subfloor work poses significant trip/fall hazards and eye hazards from
airflow-borne debris. Eye protection must be worn at all times when removing or
replacing floor tiles and when working in or around areas with removed tiles.
Safety Warning: Installation of this equipment must be in accordance with local and
national electrical codes.
Safety Warning: This product contains Lithium metal primary cell batteries, which
are NOT rechargeable. Recharging can cause battery leakage or cause the safety
release vent to open. Inadvertent charging can occur if battery installation is
backwards. Dispose of batteries appropriately after use.
Safety Warning: Lithium metal batteries may pose a fire, explosion, or burn hazard
if misused. Do not open batteries, dispose of in fire, heat above 100° C (212° F), expose
contents to water, recharge, put in backwards, or mix with used or other battery types
as this may cause the batteries to explode or leak and cause personal injury.
Safety Warning: Lithium metal batteries must be properly packed and shipped in
accordance with transportation standards.