Safety Instructions

Forbidden
Absolutely do not modify, disassemble or
repair by yourself. Negligence may cause
fire or mechanical trouble of the chair which
may result in hazard on the body.
ŏ After checking, if the problem is caused by none of the above, switch off the power, unplug the
power cord, and contact your dealer or our service center for repairs.
ŏ Prior to operating the unit when it has not been used for a long period of time, read this manual
carefully and make sure that the unit is still in good condition to avoid accident or injury.
Follow the
instructions
A “clatter” noise occurs when the knead balls go up and down.
A “creak” noise of the gear and the motor occurs while in massage.
A friction noise occurs when the knead balls rub the cover cloth.
A rattling noise occurs while in the “Tap” or “Knead and Tap” massage movements (particularly when the
massage moves from the shoulders to the back).
In the “Knead”, “Tap”, or “Knead and Tap” massage movements, massaging speed may vary with the knead
balls’ strength changed.
A roaring noise of the motor occurs when load is given to the chair.
A “cuckoo” noise occurs while in the auto mode course, the knead balls are automatically adjusted to the
back-and-forth position to have the chair fitting in with the user’s body shape.
The compressor’s noise and the air exhausting noise
occur while in air-massage.
A noise occurs when the air bag is inflated.
A noise occurs while in massage of the shoulders.
A grinding noise occurs when the backrest is reclined.
There is a humming sound from the pump.
Controls
No massage course has been selected.
Check whether the button on the control
has been pressed.
Press the button on the control.
Select a massage course.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate equipment.
FCC RF Radiation Exposure Statement:
1. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
2. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with a minimum distance of 20 centimeters between the
radiator and your body.