Install Instructions

SYNCOMM Proprietary

and (10). Then press the plastic cap ( component (14) ) into

component (3).

Step4:

Screw two antenna sets( component (11) and component (13) )

onto the two sides of component (3) tightly with antenna facing the

outer side.

Step 5:

Fix the radio port ( component(1) ) on the rack by M6*20 screws

with grommet or spring grommet between the screw and screw nut

using components (6), (8), (9), and (10), and the installation is

complete.

Step 6:

According to figure 5-4, connect ANT0, ANT1, LINE cable, and the

EARTH cable to the RP.