Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397

PPM-4024 - 2 Gallon Air Tank Mount Kit

Kit Contents:

• (2) Tank Mount Brackets

• (4) U-Bolts

• (8) .25” Nuts

Advisory: There are two metal tubes located directly above the round Cross Member where the brackets attach.

DO NOT attach the U-Bolts over the small metal tubes. The U-Bolts must run between the steel tubes and the

round cross member.

1. Underneath the Jeep, place the U-Bolts between the wire bundle and steel tube as indicated in the following

picture:

2. Place the tank mount bracket into position and firmly hand tighten all four nuts on the passenger side.

PAGE 1
SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397 PPM-4024 - 2 Gallon Air Tank Mount Kit Kit Contents: • (2) Tank Mount Brackets • (4) U-Bolts • (8) .25” Nuts Advisory: There are two metal tubes located directly above the round Cross Member where the brackets attach. DO NOT attach the U-Bolts over the small metal tubes. The U-Bolts must run between the steel tubes and the round cross member. 1.
PAGE 2
Advisory: If you have an automatic transmission the two transmission cooler hoses can easily be bent downward by hand, in order to allow clearance for the driver’s side tank bracket. 3. Install the driver’s side bracket again threading the U-Bolts between the two metal tubes and round Cross Member. Again firmly hand tighten four nuts on the U-Bolts. (General position is indicated in the picture after step #6) 4. Place the tank into position. This is usually done from above.