Hardware Installation Guide

7
Chapter 2: Hardware Setup
b
Secure the drive with the screws provided.
•
For 2.5” drives:
a
Place the drive in the 2.5" Disk Holder (Type C, sold separately), and then tighten the 2.5" screws to
secure the drive.
b
Slide the 2.5" Disk Holder into the hard drive bay, and push it all the way until the drive is rmly connected
to the SATA connector. Secure the Disk Holder with the provided screws.
3
Replace the upper case, and tighten the screws on the back panel.