User's Manual

14
Chapter 2: Hardware Setup
To make sure your Synology NAS recognizes the new memory capacity
1
Install DiskStation Manager (DSM). Please see "
Install DSM on Synology NAS
" for more information.
2
Sign in to DSM as
admin
or a user belonging to the
administrators
group.
3
Go to
Control Panel
>
Info Center
and check
Total Physical Memory
.
If your Synology NAS does not recognize the memory or does not start up successfully, please make sure that
the memory module is installed correctly.
To remove the memory module
1
Follow step 1 to 3 of the
"To install the memory module"
section to shut down your Synology NAS,
disconnect the cables and remove the cover.
2
Push the levers on both sides of the memory module outward. The memory module will be released from its
slot.
3
Hold the memory module by its edges and remove it from the slot.
4
Replace the cover and tighten the two screws that removed.
5
Reconnect the cables that removed, then press the power button to turn on your Synology NAS.