User's Manual
Table Of Contents
16
Chapter 2: Hardware Setup
To remove the memory module
1
Follow step 1 and 2 of the "
To install the memory module
" section to shut down your Synology NAS,
disconnect the cables and remove the top cover.
2
Remove the memory module from the slot:
a
Push the levers on both sides of the memory module outward. The memory module will be released from
its slot.
b
Hold the memory module by its edges and remove it from the slot.
a
b
c
3
Replace the top cover by following step 5 of the "
To install the memory module
" section.
4
Reconnect the cables removed in step 1, then press the power button to turn on your Synology NAS.