Installation guide

12 Chapter 2: Hardware Setup
Confirm New Memory is Recognized
After installing a new memory module in the RackStation, we recommended checking whether or not the system
recognizes the new memory.
To check the memory of the RackStation:
1 Start up your RackStation. (See “Start up the RackStation” for more information.)
2 Install DSM. (See “Chapter 3: Install DSM on RackStation” for more information.)
3 Log in to Synology DiskStation Manager (DSM) with an account belonging to the administrators group.
4 Check Total Physical Memory at Control Panel > Info Center.
If the RackStation does not recognize the memory or does not start up correctly, please make sure the memory
was correctly installed.
Remove RAM Module from RackStation
1 Follow steps 1 to 4 of “Install a RAM Module” to remove the cover from the RackStation.
2 To remove the RAM module, follow the steps below:
a Release the ejectors on the memory slot by pushing outwards simultaneously.
b Hold the memory module by the edges and remove it from the slot.
3 Replace the top cover, slide it into place, and tighten the two back screws.