User Manual

CAUTION:
Ensure the Genie is securely attached to the linear or panning accessory, No orange should be
visible on the release latch..
Important safety instructions.
READ THESE INSTRUCTIONS. KEEP THESE INSTRUCTIONS. HEED
ALL WARNINGS. FOLLOW ALL INSTRUCTIONS.
- Clean only with dry cloth.
- The Unit is a precision instrument. Do not drop it or subject it to physical shock.
- Do not use this apparatus near water. The unit is not waterproof and cannot be used under-
water. If you accidentally drop the device into water, promptly contact Syrp. Wipe off any
water droplets with a dry cloth. If the device has been exposed to salty air, wipe it with a well-
wrung wet cloth.
- Never leave the device near anything having a strong magnetic field such as a magnet or
electric motor. Also avoid using or leaving the device near anything emitting strong radio
waves such as a large antenna.
- Do not leave the device in excessive heat such as in a car or direct sunlight. High tempera-
tures can cause the device to malfunction.
- Never attempt to disassemble the device.
- If the device is suddenly brought in from the cold into a warm room, condensation may form
on the device, do not use the device. This is to avoid damaging it. If there is condensation,
remove any accessories and wait until the condensation has evaporated before using again.
- Avoid storing the device where there are corrosive chemicals such as a darkroom or chemi-
cal lab.
- Do not use or leave the device or battery charger in a hot environment. Doing so may cause
battery leakage or a shorter battery life. The device can also become hot and cause skin
burns.
- Do not use paint thinner, benzene, or other organic solvents to clean the equipment. Doing
so may cause fire or a health hazard.
- Do not use or charge near any heat sources such as radiators, heat registers, stoves, or
other apparatus (including amplifiers) that produce heat.
- Only use attachments/accessories specified by the manufacturer.
- Use only with the tripod, stand, slider, ballhead or support apparatus specified by the manu-
facturer, or sold with the apparatus. When apparatus are used, use caution when moving or
transporting to avoid injury from tip-over.
- Refer all servicing to qualified service personnel. Servicing is required when the device has
been damaged in any way, such as power-supply cord or plug is damaged, liquid has been
spilled, objects have fallen onto the apparatus, the apparatus has been exposed to rain or
moisture, does not operate normally, or has been dropped.
PREVENTING FIRE, EXCESSIVE HEAT, CHEMICAL LEAKAGE, AND
EXPLOSIONS, FOLLOW THE SAFEGUARDS BELOW:
- Do not use any external batteries, power sources and accessories not specified by Syrp. Do
not use any home-made or modified external power supply or batteries.
- Do not short-circuit, disassemble, or modify the device or battery inside. Do not apply heat
or apply solder to the internal battery or any attached external devices. Do not expose the