Quick Start Guide

Threading the Linear Plate
1
Thread an untied end of the rope into the bottom of the roller
where it’s marked ‘IN’ following the arrow.
Thread the rope end through to the bottom of the next roller
marked ‘OUT’.
Ensure the rope is sitting at the bottom of the roller.
2
Continue to thread the rope through the next 2 rollers
marked T5.
3
Repeat the above steps 3 more times, stacking each wind
above the last.
Ensure each rope sits individually in the grooves of the
Guide Rollers
The Capstan is pre-wound,
avoid removing unless
absolutely necessary
Continued overleaf.