Quick Start Guide

ManualsBrandsSyrp ManualsCamera SlidersMagic Carpet PRO Short Slider Kit

UNLOCK

Remove Track Joiners

Lift open both Track Locks and pull out the

Track Joiners.

The Track Joiners are only required when

joining multiple tracks together.

Before you start ﬁlming, there are a few simple steps

to follow to ensure your Magic Carpet PRO is

assembled correctly and you’re sliding smoothly.

This guide will walk you through the correct Magic

Carpet Pro set up, as well as some helpful tips.

Setup Guide

Additional resources can be found at

support.syrp.co.nz

Install the Carriage

Slide the Carriage on to the Track Rails.

Ensure you lock the carriage

once installed and when not

in use.

Orientate the carriage with

the Carriage Lock on the

same side as the Flywheel

Tread!

Carriage

Lock

Flywheel

Tread

LOCK

Install the End Caps

Unlock both the Track Locks and insert the

End Caps.

Close the Track Locks securing the End

Caps in place.

Insert evenly with the

End Caps ﬂush with the

Track Ends.

LOCK

UNLOCK

Remove the Quick Release Plate

Slide the Quick Release Lock to unlock and

push in while pulling the Plate up to remove.

PUSH IN

FIRMLY TO

UNLOCK

Adjust the Legs

Lift open the Leg Locks to release the legs

and set the leg angle.

Fine leg adjustment can be

achieved by twisting the

foot.

LOCK

UNLOCK

Summary of content (2 pages)

PAGE 1
Remove Track Joiners Install the Carriage 1 Lift open both Track Locks and pull out the 2 Slide the Carriage on to the Track Rails. Track Joiners. Setup Guide The Track Joiners are only required when joining multiple tracks together. Before you start ﬁlming, there are a few simple steps to follow to ensure your Magic Carpet PRO is assembled correctly and you’re sliding smoothly.
PAGE 2
Fasten Quick Release Plate Mount Camera Engage Flywheel 6 Screw the Quick Release Plate to your video 7 Push the Quick Release Plate down into the 8 Press the Flywheel button in to engage or head. carriage. You will hear a click when it’s ﬂush and engaged. Slide the Quick Release Lock to lock. release the Flywheel. ! IMPORTANT Do not lift the Track by your camera or attached accessory. FLY PULL TO RELEASE SWAP WH E EL ! Ensure the Quick Release Plate is always locked in place once installed.