User's Manual

User Manual: Field Transmitter
PCU_User_Guide_1.3.0 6 © 2019 Syscor Controls & Automation Inc.
2.4 Wiring Sensors to the Power and Communication Unit
Up to two sensor probes may be connected to the PCU. Sensor probes may be screwed directly into the PCU
ports or mounted remotely. For systems with zero sensor probes, ensure both PCU cable glands have a plug
installed. Plugs are shipped with every PCU but can be purchased from the manufacturer separately if
misplaced or lost. Please read the warnings regarding field replacement at the end of section 2.4.
Figure 10: Direct mounted PTFE tape application
(See 2.4.1 for installation instructions)
Figure 12: Direct and remote sensor probe wire preparation
(see 2.4.1 or 2.4.2 for installation instructions)
Figure 11: Inserting plug into unused gland
Figure 9: Remote and directly mounted units