User's Manual

User Manual: Field Transmitter

WARNING: Substitution of components not expressly specified by Syscor will void intrinsic safety

certification.

1.2.2 Federal Communications Commission (FCC) Part 15

This device complies with FCC Rules Part 15 operation and is subject to the following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference, including interference that may cause undesired operation

of the device.

Changes or modifications to this device, not expressly approved by Syscor Controls & Automation Inc. could

void the user’s authority to operate the equipment.

FCC RF Exposure Requirements:

This product complies with the FCC RF exposure limit set forth for an uncontrolled environment and is safe

for intended operation as described in this manual. This device is only authorized for use in a mobile

application, at least 20 cm of separation distance between the radiating antenna and the user's body must

be maintained at all times. Further RF exposure reduction can be achieved if the product can be kept as far

as possible from the user’s body or set the device to a lower output power if such a function is available.

Separate approval is required for all other operating configurations, including portable configurations with

respect to 47 CFR Part 2.1093 and different antenna configurations.

1.2.3 Industry Canada

This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the following two

conditions:

1. This device may not cause interference; and

2. This device must accept any interference, including interference that may cause undesired operation

of the device.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de

licence. L’exploitation est autorisée aux deux conditions suivantes:

1. L’appareil ne doit pas produire de brouillage;

2. L’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est

susceptible d’en compromettre le fonctionnement.

1.2.4 Antennas

The radio transmitter 11413A-000697 is approved by to operate with the antenna types listed below. Antenna

types not included in this list, or having a gain greater than the maximum gain indicated for that type, are

strictly prohibited for use with this device. In order to comply with FCC regulations pertaining to the use of

generic antenna connectors, this device must be professionally installed.

1) Omni-Directional Antenna Type

a. Maximum permissible gain of 12.0dBi (North America) or 6.0dBi (Europe)

b. Impedance 50 Ω

c. <10000mm

non-metallic surface area. If used with any length extension cable ignore this

requirement.

2) Patch Antenna Type

a. Maximum permissible gain of 4.9dBi (North America and Europe)