User's Manual

20
T
T
r
r
o
o
u
u
b
b
l
l
e
e
s
s
h
h
o
o
o
o
t
t
i
i
n
n
g
g
Wireless RF Keyboard & Mouse not detected
If the keyboard and mouse don’t respond to activity, follow these steps:
1. Ensure that the receiver cable is properly connected to the PS/2 mouse
and keyboard ports (refer to Setting up Your Keyboard and Mouse on
page 7). Ensure that the purple connector is connected to the keyboard
port, and the green connector is connected to the mouse port.
2. Ensure that the batteries have been installed correctly (refer to Inserting
Batteries page 5).
3. Ensure that there are no IRQ or I/O address conflicts. Refer to your op-
erating system user’s manual for information on resolving IRQ and I/O
address conflicts.
4. Ensure that you have established a connection between the RF receiver
and the keyboard/mouse (refer to Setting up Your Keyboard and Mouse
on page 7).
Wireless RF Keyboard & Mouse don’t work after changing batteries
If the keyboard and mouse don’t respond to activity after replacing the batteries,
follow these steps:
1. Ensure that the batteries have been installed correctly (refer to Inserting
Batteries page 5).
2. Ensure that the batteries are not discharged.
3. Ensure that you have established a connection between the RF receiver
and the keyboard/mouse (refer to Setting up Your Keyboard and Mouse
on page 7).
Cursor doesn’t move properly on the screen
If the cursor doesn’t move or the motion is erratic, follow these steps:
1. Ensure that you have established a connection between the RF receiver
and the keyboard/mouse (refer to Setting up Your Keyboard and Mouse
on page 7).
2. Change the position of the RF receiver. There should be a distance of at
least 8 inches (20 cm) between the receiver and any electrical appliance
(such as speakers, the monitor, or the computer).
3. Ensure that the mouse batteries are not discharged. If they are dis-
charged replace them (refer to Inserting Batteries page 5).