User's Manual

SHENZHEN SYS IoT CO., LTD. 5 / 34
Tel: [phone]
Fax: [phone]
Mail: [e-mail]
Http://www.sysiot.cn
Add: Room 716, Yiben E-Commerce
and Industrial Park, Chaguang Road
Nanshan District, Shenzhen, China
Post Code：518055
1) "Connection & Read EPC": connecting module, setting and querying device address, and single-tag
and multi-tag reading EPC data etc;
2) "System Setting": system setting, setting the operation of the reader GPIO port control, RF output
power, frequency and antenna parameters;
3) "Access Tag Memory": access to the tag’s memory, including the function of reading tags, writing
tags, locking tags, and destroying tags;
4) "Sensor Tag": sensor tag function, demonstration function for rfid tag operation with temperature
and moisture sensor;
5) "Test & Modem Setting": environmental test and modulation chip settings; a general evaluation test
of the electromagnetic environment monitoring of the reader and the adjustment of the module
modulation chip parameters.
Please note, in general, the parameters of Module modulation chip are no need to set it by user, and it
is set by professional engineers according to the environmental conditions on site.
Picture 1
The software interface is shown in picture 1 above; different areas have differentfunctions.
1) Function switch: Different DEMO functions can be selected by clicking the switch property page;
2) Communication connection: Connecting the reader module for communication by selecting the
serial port and device address;
3) Tag data: The area showing the tag data read by the module, including EPC data (EPC+PC) and
CRC value of the tag, signal strength RSSI of the tag reply, amount of tags and antenna port of
reading the tag;
4) Communication frame data: Recording and displaying the command frame and response frame data
packet of the entire communication process of DEMO software and reader module, which can
facilitate users to know the communication frame process;
5) Information display: Notification of the operation process of DEMO software;