Instructions / Assembly

System1738 Installation Methods 25

Universal Concentric Vent Kit (UCVK

) Assembly

1. Ensure that the Universal Concentric Vent Kit is

configured to fit your venting system by following

the instructions outlined with the Configuration

guide.

2. Once the installer has determined the termination

location, cut a hole in the roof or wall 1/2" larger

than the “C” dimension referenced in Table 6 for the

part being installed.

3. As per the procedures outlined in the System 1738

Installation Guide, solvent weld the inner pipe to the

internal 3" reducer elbow.

4. Solvent weld the outer pipe to the pipe socket.

5. Slide the pipe assembly through the roof or wall

penetration. (Install flashing if needed).

6. The outer pipe shall be only a friction fit with the

cap. To permanently affix the rain cap, apply

solvent cement to the inner pipe as per the

procedures outlined in this guide. For installations

where removal of the cap may be required for

service of the termination or cleaning the vent, it

can be fastened mechanically.

7. Once the rain cap is installed, and the kit secured

as outlined, the kit can be solvent welded to the

appliance.

8. Vertical pipe lengths to accommodate the

termination height of the Universal Concentric

Vent Kit Unit are field supplied. Additional venting

accessories such as vent screens are sold

separately.