Data Sheet

RM9000
Multiprotocol 2.4GHz Wireless Module
Datasheet
9 / 17
System Design Co., Ltd.
When measured on the CC1352PEM-XD7793-XD24-PA24 reference design with T
c
= 25 °C, V
DDS
= 3.0 V with DC/DC
enabled unless otherwise noted.
PARAMETER
TEST CONDITIONS
TYP
UNIT
Core Current Consumption
I
core
Reset and Shutdown
Reset. RESET_N pin asserted or VDDS below power-on-reset
threshold
150
nA
Shutdown. No clocks running, no retention
150
Standby
without cache
retention
RTC running, CPU, 80KB RAM and (partial) register retention.
RCOSC_LF
0.94
µA
RTC running, CPU, 80KB RAM and (partial) register retention
XOSC_LF
1.09
µA
Standby
with cache retention
RTC running, CPU, 80KB RAM and (partial) register retention.
RCOSC_LF
3.2
µA
RTC running, CPU, 80KB RAM and (partial) register retention.
XOSC_LF
3.3
µA
Idle
Supply Systems and RAM powered
RCOSC_HF
675
µA
Active
MCU running CoreMark at 48 MHz
RCOSC_HF
3.39
mA
Peripheral Current Consumption
(1) (2)
I
peri
Peripheral power
domain
Delta current with domain enabled
97.7
µA
Serial power domain
Delta current with domain enabled
7.2
RF Core
Delta current with power domain enabled,
clock enabled, RF core idle
210.9
µDMA
Delta current with clock enabled, module is idle
63.9
Timers
Delta current with clock enabled, module is idle
(5)
81.0
I2C
Delta current with clock enabled, module is idle
10.1
I2S
Delta current with clock enabled, module is idle
26.3
SSI
Delta current with clock enabled, module is idle
82.9
UART
Delta current with clock enabled, module is idle
(3)
167.5
CRYPTO (AES)
Delta current with clock enabled, module is idle
(4)
25.6
PKA
Delta current with clock enabled, module is idle
84.7
TRNG
Delta current with clock enabled, module is idle
35.6
Sensor Controller Engine Consumption
I
SCE
Active mode
24 MHz, infinite loop
808.5
µA
Low-power mode
2 MHz, infinite loop
30.1
(1) Adds to core current I
core
for each peripheral unit activated.
(2) I
peri
is not supported in Standby or Shutdown modes.
(3) Only one UART running
(4) Only one SSI running
(5) Only one GPTimer running
4.6 Power Consumption - Radio Modes
When measured on the CC1352PEM-XD7793-XD24-PA24 reference design with T
c
= 25 °C, V
DDS
= 3.0 V with DC/DC
enabled unless otherwise noted.
High-power PA connected to V
DDS
unless otherwise noted.
PARAMETER
TEST CONDITIONS
TYP
UNIT
Radio receive current
2440 MHz
6.9
mA
Radio transmit current
2.4 GHz PA (BLE)
0 dBm output power setting
2440 MHz
7.3
mA
+5 dBm output power setting
2440 MHz
9.6
mA
(1) Measured on evaluation board as described in Optimizing the CC1352P and CC2652P for Coin Cell Operation at 10 dBm Output
Power.