MSDS

Sculpwood Paste Part A (cont.)
EMERGENCY AND FIRST AID PROCEDURES:
Eyes: Flush with water for 15 minutes holding eyelids open. Seek medical attention.
Skin: Remove contaminated clothing and shoes and wipe excess off skin. Flush skin with water. Follow by washing in
soap and water. If irritation occurs, seek medical attention. Do not reuse clothing until cleaned. Contaminated
leather articles (shoes) cannot be decontaminated and should be destroyed.
Inhalation: Remove victim to fresh air and provide oxygen if breathing is difficult. Give artificial respiration if not
breathing. Get medical attention.
Ingestion: Do not give liquids if victim is unconscious or very drowsy. Otherwise, give no more than 2 glasses of water
and induce vomiting by giving 2 tablespoons syrup of ipecac (1 tablespoon and 1 glass of water for child). If
ipecac is unavailable, give 2 glasses of water and induce vomiting by touching finger to back of throat. Keep
head below hips while vomiting. Get medical attention.
Medical Conditions Generally Aggravated by Exposure: Other than skin sensitization which appears to be permanent,
epoxy resin does not appear to cause long term health effects. Nor, does it appear to aggravate other medical conditions.
SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND USE
If Material is Spilled: Avoid contact with material. Persons not wearing appropriate protective equipment should leave the
area of the spill until cleanup is complete. Stop spill at source, dike area to prevent spreading, pump liquid to
salvage tank or drum. Remaining liquid may be taken up on clay, diatomaceous earth, sawdust, or other
absorbent, and shoveled into disposal containers.
Waste Disposal Method: Waste is not hazardous by RCRA criteria (40 CFR 261). Place in an appropriate disposal
facility in compliance with local regulations.
SECTION VIII - SPECIAL PROTECTION INFORMATION
Respiratory Protection: Normally none is required when adequate ventilation is provided. In the absence of proper
environmental control NIOSH approved respiratory is required. For emergencies, a self-contained breathing
apparatus or full-faced respirator is recommended.
Ventilation: Provide adequate ventilation in work areas. Confine material in sealed containers when not in use.
Hand Protection: Always wear impervious gloves, neoprene, vinyl or rubber.
Eye Protection: Splash proof goggles or safety spectacles with side shields are recommended. Always wear eye
protection when sanding cured epoxy resins to avoid dust in eyes.
Other Protective Equipment: Wear clean, body-covering clothing to avoid skin contact.
SECTION IX - TRANSPORTATION REQUIREMENTS
Transportation of Dangerous Goods Classification: Not regulated
Consumer warnings: Caution: Irritant, skin sensitizer.
Canada NSNR: All components in this product are on the Domestic Substances List.
Department of Transportation Classification: Not Hazardous
U.S. D.O.T. Proper Shipping Name: Not Regulated
Other Requirements:
This product contains no toxic chemicals subject to the report requirements of Section 313 of the Emergency Planning
and Community Right-To-Know Act of 1986 (and of 40 CFR 372).
The information contained herein is based on the data available to us and is believed to be correct. However, System Three Resins, Inc. makes no
warranty, expressed or implied, regarding the accuracy of these data or the results to be obtained from the use thereof. System Three assumes no
responsibility for injury from the use of the product described herein.