MSDS

Sculpwood Paste Part B (cont.)
Chronic: Prolonged and repeated skin contact may cause skin sensitization, asthma or other allergic responses.
Carcinogenicity: Results of in vitro mutagenicity tests on ethylene amines have been negative. It is not expected that any
of the ingredients are carcinogenic.
EMERGENCY AND FIRST AID PROCEDURES:
Eyes: Flush thoroughly with water for at least 15 minutes. Get immediate medical attention.
Skin: Remove contaminated clothing and flood area with water. Wash affected skin with soap and water. Wash clothing
before reuse. Discard shoes. Get medical attention if redness, soreness, or blistering occur or persist.
Inhalation: Remove to fresh air. Administer oxygen if necessary. Get medical attention if breathing is difficult or cough
develops.
Ingestion: DO NOT INDUCE VOMITING. Vomiting will cause further damage to throat or respiratory tract. Dilute by giving
water or milk to drink if victim is conscious. GET IMMEDIATE MEDICAL ATTENTION.
Medical Conditions Generally Aggravated by Exposure: This material may be a strong skin sensitizer in certain susceptible
persons. Once sensitized, most persons are unable to work around amine cured epoxy resins without an allergic
reaction. Sensitized persons are not known to have other health problems as a result of sensitization.
SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND USE
If Material is Spilled: Avoid contact with material. Persons not wearing appropriate protective equipment should leave the
area of the spill until cleanup is complete. Stop spill at source, dike area to prevent spreading, pump liquid to
salvage tank or drum. Remaining liquid may be taken up on clay, diatomaceous earth, sawdust, or other
absorbent, and shoveled into disposal containers.
Waste Disposal Method: Waste is not hazardous by RCRA criteria
(40 CFR 261). Place in an appropriate disposal facility in compliance with local regulations.
SECTION VIII - SPECIAL PROTECTION INFORMATION
Respiratory Protection: Normally none is required when adequate ventilation is provided. In the absence of proper
environmental control NIOSH approved respiratory is required. For emergencies, a self-contained breathing
apparatus or full-faced respirator is recommended.
Ventilation: Provide adequate ventilation in work areas. Confine material in sealed containers when not in use.
Hand Protection: Always wear impervious gloves, neoprene, vinyl or rubber.
Eye Protection: Splash proof goggles or safety spectacles with side shields are recommended. Always wear eye
protection when sanding cured epoxy resins to avoid dust in eyes.
Other Protective Equipment: Wear clean, body-covering clothing to avoid skin contact.
SECTION IX – OTHER REQUIREMENTS
U.S. Department of Transportation Classification and T.D.G. Classification: Not regulated
Consumer Warnings: None.
Canada NSNR: All substances in this product are on the Domestic Substances List.
SARA Title III:
This product contains no toxic chemicals subject to the report requirements of Section 313 of the Emergency Planning and
Community Right-To-Know Act of 1986 and of 40 CFR 372.
The information contained herein is based on the data available to us and is believed to be correct. However, System Three Resins, Inc. makes no
warranty, expressed or implied, regarding the accuracy of these data or the results to be obtained from the use thereof. System Three assumes no
responsibility for injury from the use of the product described herein.