TPI 38 CFC201402
Clean areas
|
9 / 11
Accessories
Front diffuser panels, ventilation grilles
The clean ltering cassettes are delivered with diffuser
panels, or grilles, respectively. From the design and
parameter perspective they are identical to the
standard systemair products, the only difference is
in the outer dimensions. Further information about
the parameters is therefore available in the technical
documentation for the standard products. The technical
documentation codes (TPI...) can be found in Tab. 10.
The dimensions of the corresponding standard products
are in the dimension part of Tab. 10, entered in brackets
and marked with an asterisk (*). These accessories
are standardly ordered along with the clean ltering
cassette. It is needed to specify the panel or grille type
in the ordering code. The surface nish and dimensions
will be automatically adjusted to match the specic
clean ltering cassette.
Fig. 6: The ledge for mounting into a metal plate ceiling or a T-bar ceiling
NOTE: By default, the ledge is supplied already mounted onto the clean
ltering cassette, if the mounting into a specic ceiling type is entered in
the ordering code.
Ledge for mounting into a metal plate ceiling or T-bar ceiling
When mounting the clean ltering cassette into a metal plate
ceiling or a T-bar ceiling, the clean ltering cassette is equipped
with ledges to adjust the given clean ltering cassette
dimensions to the installation opening size (position 4 on Fig.
8, 9). It is needed to specify the respective information into the
„Ceiling type, raster“ eld in the ordering code. The ledges are
manufactured from a steel sheet with the same surface nish
as the one chosen for the clean ltering cassette.
Fig. 7: Dimensions of front diffuser panels and grilles for the clean ltering cassettes.
A
2
× B
2
VN
A
2
× B
2
VR
AQ
A
3
× B
3
A
2
× B
2
PP NA
B
651 × 346
5
40
A
2
× B
2
SF