Installation instruction TOB, TOS, THS, THB en, sv, ru 205815 CE (A004)

GB
Installation of roof curb TOS |
9
8.2 Felt roof
Fig. 8
1. Make a hole in the roof corresponding to the dimensions.
2. Place the sheet metal of the covering plate under the edge of the roofing felt at the upper edge and along the sides,
and on top of the roofing felt at the lower edge, figure 8.
3. Fix the TOS to the roof base with nails or screws. Where there is a base with low bearing capacity, extra supports are
nailed between the roof trusses (under the roof base) and the seal plate is fitted onto these.
4. Seal all joints with a suitable sealing compound.
5. Connect to duct.
8.3 Installation of roof cowls THS/THB*
Roof cowl THS (for flat roof) and THB (for tiled roof) is mounted in the same fashion as TOS & TOB above.
*Only applicable for roof cowls THS & THB
2058151 | A004