INSTALLATION OPERATION AND MAINTENANCE INSTRUCTION CE CT003
Table Of Contents
Maintenance task Usual operation
conditions
Unusual operation conditions.
1
Each 6
months
Each
year
Each 3
months
Each 6
months
Each
year
Examine all cable connections for damage. Make sure that
the cable glands are tight against the cables.
X X
If flexible connections are installed, examine them for damage. X X
1. The unusual operation conditions are classified as follows: If a stable ambient temperature is higher than 30 °C or lower than -10° C, if the
temperature changes are large or if very contaminated air is transported.
8.2 To clean the product
Caution
• Do not clean the product with a high-
pressure washer.
• Do not clean the product with steel
brushes or sharp objects.
• Do not bend the fan impeller blades.
• Be careful not to move the balance
weights on the fan impeller.
• Remove dirt from the fan and the duct.
• If access to the fan impeller is possible, clean the fan im-
peller with a moist cloth or soft brush.
8.3 Spare parts
• For information about spare parts, send an e-mail to
support@systemair.com.
• For more information about spare parts, contact Systemair
support.
• Always use spare parts from Systemair.
• When you send an order for spare parts, include the serial
number of the product. The serial number is found on the
name plate.
9 Troubleshooting
Note:
If you cannot find a solution to your problem in this section, speak to Systemair technical support.
9