MODBUS LITE V5.01 parameter specification

MODBUS parameters "ebm-papst series 84 / 112 / 150 / 200"
_______________________________________________________________________________________
ebm-papst Mulfingen GmbH & Co. KG
Bachmühle 2 ·74673 Mulfingen, Germany ·Phone: [phone] ·Fax: [phone] ·www.ebmpapst.com ·[e-mail]
DocNo.: 634505DocNo.: 446144DocNo.:358982DocNo.:322523DocNo.:309753DocNo.:303997DocNo.:276241DocNo.:256078DocNo.:196392 ·Template: 2 dated 6 October 2003 ·File: ext001157859.doc ·Last printed 10/03/2015 15:13:00
·Page 58 of 70
Form 1003
D188 Error n-7 D189 Time of error n-7
D186 Error n-8 D18D Time of error n-8
D19E Error n-9 D19F Time of error n-9
D19C Error n-10 D19D Time of error n-10
D19A Error n-11 D19B Time of error n-11
D198 Error n-12 D199 Time of error n-12
Every time a new error is detected, the error indicator increases by 2 and the error and its timing are stored
at the address shown on the error indicator. The addresses are automatically written to by the fan.
When the error indicator reaches the final value D19E, it will be reset to the initial value D186 when the next
error is detected.
Encoding:
Error indicator:
bytes Dataindicator error of Address 
Error:
MSB
0
0
0
0
*)
0
0
0
0
LSB
BLK
HLL
TFM
0
*)
0
TFE
0
0
*)
If bit = 1, the error described below has been detected:
BLK: Locked motor
HLL: Hall sensor error
TFM: Motor overheated
TFE: Power mod overheated
*)
The errors "DC-link undervoltage" and "Phase failure" and the general fault detection "Fan bad" are not
stored, even if they are set in the motor status (see Motor status)!
Error timing:
bytes Dataherror of Time ][