Operation and Maintenance Instructions
Table Of Contents
- 1 Overview
- 2 Warnings
- 3 Warnings signs on product
- 4 Product description
- 5 Start up
- 6 Operation
- 7 Maintenance
- 7.1 Maintenance intervals
- 7.2 How to replace supply/extract air filter
- 7.3 How to clean NaviPad
- 7.4 How to clean the heat exchanger
- 7.5 How to clean the fans
- 7.6 How to clean hot water heating coil
- 7.7 How to clean the electric heating coil
- 7.8 How to clean the extract air louvres and inlet diffusers
- 7.9 Clean the outdoor air intake
- 7.10 How to clean the duct system
- 7.11 Where to reset tripped fuses
- 7.12 How to reset the manual overheat protection (EL units)
- 7.13 How to replace the fan module
- 7.14 How to replace the heat exchanger
- 7.15 Change the internal battery in control unit CU27–C
- 8 Troubleshooting
- 9 Alarms
- 10 Service
- 11 General conditions
- 12 Spare parts
16
|
Operation
6.1.5 Configuration
• System settings
• Configuration wizard (Example 4)
• Function configuration (Example 5)
• I/O allocation settings
• Alarm configuration (Example 6)
• PID controllers
The configuration wizard is a menu that simplify the procedure to Activate and Configure common accessories and
functions and Allocate it’s in- and outputs. The wizard makes necessary configurations automatically and guide the user
through limited options.
Example 4: Configuration wizard
Configuration > Configuration wizard
2022–02–04
Set up pressure control
>
Set up cooler
>
Set up changeover
>
Exit to configuration menu > Complete configuration wizard >
If the configuration wizard does not cover the desired accessory or function it can still be configured via the configura-
tion menu.
Example 5: Function configuration
Configuration > Functions > Function activation
2022–02–04
Fan compensation curves
Yes
Support control
No
Air quality control
No
To activate a function go to Function activation. Choose function to activate and set Yes in the following pop-up
menu. Values for the activated function are now visible and can be adjusted in Data Settings.
If required, allocate in- and outputs in I/O allocation settings.
214959 | A007