QUICK CONFIGURATION GUIDE ACCESS SW 4 0 1 04 TO 4 6 1 00 157618A008

How to use the configuration wizard |
3
3.1.3 Allocation
Configuration > Configuration wizard > Set up “function” > In-/Outputs
Confirm the in-/output allocation of the connected signals and sensors. Configure in-/output settings (sensor measuring
range, polarity, edit name of sensor/signal etc.) as necessary. Complete the setup by pressing Confirm In-/Outputs
and complete setup.
Configuration > ... > Set cooler > In-/Outputs 24 Jun 10:31
Analog outputs
Range output
Device Position
Cooling (SEQ-C)
0–10V Controller AO2
Digital outputs
Contact function Device Position
Cooling pump (SEQ-C) Normally open
Controller DO3
Digital Inputs
Contact function Device Position
Feedback cooling (SEQ-C) Normally open
Controller DI5
Confirm In-/Outputs and complete setup >
3.1.4 Completing the configuration wizard
A completed setup is listed as Configured in the configuration wizard menu. To make changes to an already config-
ured function, rerun the wizard or use the configuration menus described in chapter 5.
Configuration > Configuration wizard
24 Jun 10:31
Set up pressure control
>
Set up cooler Configured
>
Set up changeover
>
Exit to configuration menu > Complete configuration wizard >
Select Complete configuration wizard once the desired setups have been completed. The configuration wizard
is still accessible from the configuration menu.
3.1.5 Operation settings
Note that functions configured via the wizard still require adaptation of its operation settings. These settings are found
in the functions submenu of Data & Settings as described in chapter 5.
157618 | A008