Operation and Maintenance Instructions
Table Of Contents
- 1 Overview
- 2 Warnings
- 3 Warnings signs on product
- 4 Product description
- 5 Start up
- 6 Operation
- 7 Maintenance
- 7.1 Maintenance intervals
- 7.2 How to replace supply/extract air filter
- 7.3 How to clean NaviPad
- 7.4 How to clean the heat exchanger
- 7.5 How to clean the fans
- 7.6 How to clean hot water heating coil
- 7.7 How to clean the electric heating coil
- 7.8 How to clean the extract air louvres and inlet diffusers
- 7.9 Clean the outdoor air intake
- 7.10 How to clean the duct system
- 7.11 Where to reset tripped fuses
- 7.12 How to reset the manual overheat protection (EL units)
- 7.13 How to replace the fan module
- 7.14 How to replace the heat exchanger
- 7.15 Change the internal battery in control unit CU27–C
- 8 Troubleshooting
- 9 Alarms
- 10 Service
- 11 General conditions
- 12 Spare parts
Maintenance
|
29
Fasten the damper
14.Insert the damper in the area above the exchanger.
Caution
Do not drag the damper on the exchanger.
15.Lift the damper with the short end on the rail at the outer beams. Observe the small hooks to secure the damper.
16.Fasten the damper by fastening the damper rails with the bolts.
Mount the doors
17.Place the doors in position.
18.Unite the hinges and replace the pin.
214959 | A007