Operation and Maintenance Instructions
Table Of Contents
- 1 Overview
- 2 Warnings
- 3 Warnings signs on product
- 4 Product description
- 5 Start up
- 6 Operation
- 7 Maintenance
- 7.1 Maintenance intervals
- 7.2 How to replace supply/extract air filter
- 7.3 How to clean NaviPad
- 7.4 How to clean the heat exchanger
- 7.5 How to clean the fans
- 7.6 How to clean hot water heating coil
- 7.7 How to clean the electric heating coil
- 7.8 How to clean the extract air louvres and inlet diffusers
- 7.9 Clean the outdoor air intake
- 7.10 How to clean the duct system
- 7.11 Where to reset tripped fuses
- 7.12 How to reset the manual overheat protection (EL units)
- 7.13 How to replace the fan module
- 7.14 How to replace the heat exchanger
- 7.15 Change the internal battery in control unit CU27–C
- 8 Troubleshooting
- 9 Alarms
- 10 Service
- 11 General conditions
- 12 Spare parts
14
|
Operation
6.1.2 Flow chart
Flow diagram
2022–02–04
199 Pa
198 Pa
18 000 m³/h
18 000 m³/h
100 %
54 Pa
34 Pa
22,1 °C
22,1 °C
-6,8 °C
-12,2 °C
71 %
74 %
16,7 °C
21,8 °C
19,9 °C
25 % RH71 % RH
32 % RH
84 %
h
Open
Open
0 %
OFF
42 %
ON
Dynamic flow chart of current configured air handling unit. Active sensors and components are visible
with values shown in real time. When pressing on values or items marked in blue you will be forwarded
to related settings and/or overview page.
6.1.3 Language
Settings of language.
• To synchronize NaviPad with all connected air handling units, go to system dashboard by pressing the
NaviPad button. Press
and , choose language.
• Using
in selected air handling units homepage via NaviPad or computer will only change language
in the selected air handling unit.
214959 | A007