Installation Instruction
Table Of Contents
- 1 Product information
- 2 Overview
- 3 Warnings
- 4 Unloading from trailer
- 5 Transport and storage
- 6 Unpacking
- 7 Duct connections
- 8 Internal components
- 9 Installation
- 10 Electrical connections
- 11 Connection of water heating coil
- 12 Access control system
- 13 Connect accessories in Control unit CU27-C
- 14 Dimensions and weight
- 15 Technical data
- 16 Additional equipment
- 17 Disposal
- 18 EU Declaration of Conformity
- 19 UK Declaration of Conformity
14
| Installation
9.2.2 Disassembly size SC 60-70, TC 60-70
Disassemble the middle section for transport through smaller openings (min 900 mm).
Heaviest part is the heat exchanger: 48 kg x 2.
Table 2 Tools required
Allen key, 8 mm (5/16"), torx 20, screwdriver, drive pin punch
Warning
• Follow the instruction carefully.
• Do only perform disassembly if your technical knowledge is sufficient.
• More than one person is needed to disassembly safely. Stand on stable ground when disassembly.
Remove the doors
1. Remove the cover over the hinges with a screwdriver.
2. Remove the hinge pins
3. Remove the doors on front and back side.
Remove damper
Warning
Beware of sharp edges. Use gloves and protective clothing.
4. Loosen the bolts holding the damper rails. Remove the damper rails.
5. Rotate the damper and lift in the direction away from the exchanger.
6. Lift the damper out from the middle section.
Caution
Do not drag the damper on the exchanger.
214958 | A007